Novak Conversions Jeep Wrangler TJ engine mounts

Should I be worried?

LittleGiant

TJ Enthusiast
Original poster
Supporting Member
Joined
Aug 20, 2023
Messages
395
Location
Honolulu, HI
My valve cover is covered in what looks like old dirt and oil. When wiping it clean I noticed what appears to be a leak. Thoughts?

I also noticed that the 2 air lines have quite a bit of wiggle up and down.

IMG_2040.jpeg


IMG_2041.jpeg
 
Most engine compartments look like that until you clean them. Spray some degreaser, rinse, repeat. Once it's clean, you can keep an eye on it to see where the oil is seeping from.
 
  • Like
Reactions: LittleGiant
Clean it off good and then see if the oil / grease returns.

Has it always been like this or did you just recently notice it?
 
Replace it. It’s a real pain to get the old brittle ones out too. When you break it off and part of it falls into the valve train area…..there’s a baffle under it that actually is pretty good at keeping you from dropping anything into the actual valve train.
 
  • Like
Reactions: LittleGiant
Found an older thread where the part numbers were posted for front and back as well as the grommets. Just ordered them.

Thank you. I’ll keep an eye on it after I have it cleaned off and the valves replaced
 
  • Like
Reactions: TJ Jim and lBasket
Novak Conversions Jeep Wrangler TJ engine mounts