Long story short, I've had to extend the TPS cable for my supercharger setup, and while I'm getting readings, the voltage is looking low in the scanner tool from MPVI3.
Although through the diagnostics tool no errors are being seen.
Would anyone know the voltage readings I would expect to see at WOT?
If I where to replace the wires going back to the brick connector, does anyone know the pin-outs?
Much appreciated
Although through the diagnostics tool no errors are being seen.
Would anyone know the voltage readings I would expect to see at WOT?
If I where to replace the wires going back to the brick connector, does anyone know the pin-outs?
Much appreciated
