Soft Top Door Seal

[Christian.mers]

I’m sure this is out there somewhere but I wasn’t wondering what you all would do to fix this?

My soft top upper doors don’t make a correct seal and that causes water to leak in every single time it rains. My soft top hold down plastic has broken as well.

 

[glowell222]

Looks like you need to adjust your half doors to align better. Also, how's your frame looking? And your torque boxes? Also, how is the A-pillar plastic trim looking? It's this piece: https://www.quadratec.com/p/mopar/windshield-door-seal-wrangler-tj

 

[Christian.mers]

Looks like you need to adjust your half doors to align better. Also, how's your frame looking? And your torque boxes? Also, how is the A-pillar plastic trim looking? It's this piece: https://www.quadratec.com/p/mopar/windshield-door-seal-wrangler-tj

Ground down some of the torque boxes and frame, a little rusty in and out but I’ve seen far worse. Need to jack up and undercoat it. Not sure what I’m looking for on the trim pieces

 

[glowell222]

Ground down some of the torque boxes and frame, a little rusty in and out but I’ve seen far worse. Need to jack up and undercoat it. Not sure what I’m looking for on the trim pieces

View attachment 641368

View attachment 641369

View attachment 641370

View attachment 641371

At the top of that trim piece is a rectangular hole, and the end of your door surrounds are supposed to go into that hole--double check that your door surrounds are in, and that area isn't broken.

 

[Christian.mers]

Still searching. Kind of just forgot to check and then the jeep went down and I just started driving it again and it stormed pretty bad (this is only from about 30 minutes)

I was parked on a slope favoring the passenger side so I’m sure water just glided off the soft top and down

 

[Moglocker]

I’m sure this is out there somewhere but I wasn’t wondering what you all would do to fix this?

My soft top upper doors don’t make a correct seal and that causes water to leak in every single time it rains. My soft top hold down plastic has broken as well.

View attachment 637620

View attachment 637621

View attachment 637622

View attachment 637623

View attachment 637624

You have to bend the metal upper frame to fit the hole.

 

[Moglocker]

I’m sure this is out there somewhere but I wasn’t wondering what you all would do to fix this?

My soft top upper doors don’t make a correct seal and that causes water to leak in every single time it rains. My soft top hold down plastic has broken as well.

View attachment 637620

View attachment 637621

View attachment 637622

View attachment 637623

View attachment 637624

And this plug with the aqueduct lines going to it should be removed and replaced with a plastic jk plug.i took a small hole punch and made a hole in them.

 

[Christian.mers]

How is this removed?? Drilled?

 

[Moglocker]

How is this removed?? Drilled?
View attachment 664752

You have to pry them out,then take a zip wheel and clean the sealer off,I then used the jk style plugs(amazon) so I can remove them to drain the floor,works perfectly then.