Front Lower Control Arm Weld In Replacement's

[Christian.mers]

Hey, hope you all are having a wonderful day. I smashed in my driver side lower control arm mount pretty good. I ordered These from Iron Rock Offroad. Haven’t welded them in yet but some things to keep in mind are that the brackets are not the same for both sides. The left and right side are mirrored and Not identical. Note that the highest point of the bracket is pointing towards the Center of the vehicle.

Additionally, these do not use any Cam bolts or have the slots to weld on to support Cam Bolts. Could anyone recommend some hardware that would be suitable for my needs? Dana 30 Front Axle

 

[Wildman]

Thread 'How do I orient Iron Rock lower control arm mounts?'

May 11, 2023

I'm getting ready to cut off the stock lower control arm mounts and install a set from Iron Rock. Per a post from @mrblaine, I'll dimple the white line area, carefully cut the weld between the shock mount and lower control arm mount, and cut off the stock control arm mount. Once that's done, I'll align the new mount with the dimples, then rotate it to contact the bottom of the shock mount, which is the reference point.

When mocking it up, I've aligned both mounts so they have the same angles. However, after doing that the Iron Rock mount doesn't look like it will contact the shock...

• Irun
• Replies: 18
• Forum: TJ General Discussion

•