PlastiDip spots

[Snukulu]

Decided to PlastiDip the wheels to see if I like the blacked out look. Followed directions, shook the can thoroughly, and still ended up with some splatter . None of it is running. I kept the first coat light. Will this disappear with a few more coats or should I just bail now, hit it with Goo Gone, powerwash them, and start all over again?

 

[macleanflood]

I think you're blazing a new trail here...might want to let it completely set up and sand out the runs and drips...then recoat.

-Mac

 

[TheBoogieman]

Decided to PlastiDip the wheels to see if I like the blacked out look. Will this disappear with a few more coats

You won't notice it after a couple more coats. Many people used to Plasti-Dip their wheels.

 

[Imagineer]

The wheels on my 2-wheel battle cruiser are Plasti-dipped. It's been on for 5 years now and it still looks decent, I recall, after coat 1, there were a few fisheye spots (I didn't clean the wheels well enough). After 3 coats, they weren't noticeable.

 

[Coadster32]

I did my Ravine rims about 4 years ago. Street driven jeep with low mileage. I don't rotate in the spare, so that look brand new still. The other 4 held up pretty well to the road. Red stripes hand painted on the plastic-dip went well also. First coat light, next two were a little heavier. Good prep is key.