Search results

I brought the parts, so they only did labor and it was over a year ago, probably won’t get A warranty.

It howls under load, just don’t feel right, with no rear shaft installed, it has too much backlash, think maybe pinion depth, I will open it up after the first of the year

Yeah, drove it today, reset the pinion angle to 1.5-1.6, the rear diff just don’t seem right, backlash just doesn’t seem right. It’s seems likely that the gears are noisy. Pisses me off, I spent good money on getting them installed… by a local offroad shop.

So latest update, went to install the ax15 to the atlas, the rear output shaft bound up. So i ordered a new input shaft for the atlas, had Novak install, and found that the inner spines from the input were binding by about.030”. So they installed the spacer plate from advanced and everything...

Pulleys are turning, so while not operating they are still turning

That was me, I think a stock configuration might not have the problems

Reality check, just on or off, don’t complicate it when it’s not necessary.

Boomer

Off to the shop

Oh by the way, this is a Novak Ax-15

Finally going to get finished. 68 with 18k original miles, swapped in a 572 hemi that I built. Bought in 1991 and I have never driven her. Envy!

Local guy had it, I got it for 1700, the bell from advanced was another 580

Utah

Explorer is the same backing plate for the 8.8

Ax15 going in, I have the rebuilt nsg for sale, this is my solution, easier than a 435, I had to tweak the shifter to get it to match up to what the original was. Now to finish the rear main seal.

Early Christmas

Advanced was prompt is shipping!

Flipping around and heat has me close

I may have a solution, need to get the ax shift tower apart and see it my measurements are close.