Novak Conversions Jeep Wrangler TJ engine mounts

Finally planning to remove the outer axle tube seals (do I need to run the oil slinger?)

Moglocker

Moglocker

TJ Expert
Original poster
Supporting Member
Joined
Mar 19, 2021
Messages
3,084
Location
St.Augustine,florida
I am finally going to remove the aftermarket outer axle tube end seals on my Dana 30)I should not have used them on it when I did the regear.i think they do more harm than good.i am running the revolution lifetime shafts with the jk joints,should i use the factory plastic oil slingers,will they even fit on these shafts?thanks-jeff

https://www.jegs.com/i/Crown-Automo...sZLuh9h8Bho1pkSeJSzKNG1_5IkKOQoXXewy5UB6pGv_m

IMG_5128.png
 
Last edited:
The RG&A shafts are larger in diameter so the stock plastic cover won't fit. FWIW, my tube ends have been open since 2019.
 
  • USA Proud
Reactions: lBasket
Since you cant run em and ever worry about mud or dirt getting in there you can flex your jeep or place a jackstand on one side of the axle and set the garden hose thing on "jet" mode or whatever to get the mud out, Ive had to do that a few times when i've unfortunately hit mud
 
  • Like
Reactions: Moglocker

Similar threads

TJMexico
I found the noise in my front end / axle
Replies
17
Views
1,951
TJ General Discussion
TJMexico
TJMexico
That'll Buff
A Hodgepodge of Questions (Another TJ Rubicon Axle Swap)
Replies
16
Views
1,419
TJ General Discussion
That'll Buff
That'll Buff
hear
Replace Dana 44 Rear Axle Bearing & Seal in 17 Easy Steps
Replies
1
Views
13,124
TJ How-to Guides
astjp2
astjp2
COYOTE83
Rear axle woes
Replies
23
Views
1,694
TJ General Discussion
Gollywomper
Gollywomper
J
Leaking Rear Axle Seal Dana 44
Replies
34
Views
7,791
TJ General Discussion
JeepinJake
J
Novak Conversions Jeep Wrangler TJ engine mounts
Top Bottom