Alright my Hp30 is now ready for leaf spring perches for it to go on my LJ......Jk

I got the day off cause of newyears day so I've just Chopped&hammered off the brackets to get some more progress on this Dana turdy
Gotta work on smoothing out the welds that I added from cutting a bit too deep and from the lows that were around the "factory" welds....with that said I'm gonna give myself the excuse to buy a cheap tube sander from Amazon and see how it treats me,I'm kinda done using a diegrinder with a burr&file so the tube sander should help me remove the rust on the tubes and finish off the tubes!
Got my gussets from Barnes cut out and they seem to fit up nicely

Now i gotta wait for my truss from Ruff stuff specialties since that's been ordered,need to buy the control arm/spring perch combo brackets from ballistic fab.
Thankfully home depot is open on newyears day,so I got some Pvc added some sandpaper that has an adhesive back (forgot where I got it from)
And I used this little contraption with a drill on the inside of the axle tubes,I wish I took a picture before sanding but it did a decent job and smoothed out the scale in ther. Just need to get some 60 grit sandpaper cause this 180 grit ain't gonna cut it....
The scale In there was pretty bad but using that pvc tool helped
Also,I saw this clean example of a BMW E34 at home depot, It's a beautiful car man