What did you do to your TJ today?

[voodooridr]

Swapped out the factory door hinge bushings for the TMR bushings, it was way easier than I was expecting which was a pleasant change.
Then shortened the JKS sway bar end links because I had them too long and retorqued the control arms

 

[AndyG]

Found a new way to make @AndyG mad.... yes mad cause we all know he is a true duck man!!!!!!

View attachment 416985

My only comment is what on earth are you doing to find that on the internet. Good way to end up on a list or have the feds show up. Pervert.

 

[macleanflood]

Found a new way to make @AndyG mad.... yes mad cause we all know he is a true duck man!!!!!!

View attachment 416985

At least someone found a practical use for a HF 12 ton press...

-Mac

 

[Austin O.]

Nice work.... I do like that colour interior with the blue too.

Thank you! As do I

 

[AndyG]

At least someone found a practical use for a HF 12 ton press...

-Mac

It’s a wonder it held up.

 

[DavidBT]

View attachment 416097

View attachment 416098

Down here in South East Arizona we sometimes get an inch or two. I like it for awhile, sure glad it goes fast

 

[PeteN95]

Installed my new winch and Steinjager rear sway bar. I know I'll lose a little articulation off road, but it handles much better on the street and I like to go fast around corners in the dirt too.

 

[NWPA Jeepy T]

Yesterday on the son's 01; he cleaned up the interior quite a bit while I re-strung the driver's seat springs. We went to take it for a test drive but he realized we hooked the t case linkage wrong. Dropped the skid, re-linked, skid back up. On his way!! No leaks we can see an the junkyard tranny works just fine!! Next up, some frame, body mount and floor welding then hopefully off to the inspection station.
On a side note, seems a bit squirrely side to side while driving. going to go through all the front and rear suspension and make sure everything is good

 

[macleanflood]

Technically this was Saturday...I let all of the smoke out of my recently warranty swapped Warn M8000 winch motor. Second motor too...3 pulls with load and they die. Ordered a 9.5 XP while I wait for Warn. I ended up using traction boards, a floor jack and a shovel and was out until 11 pm digging myself out without a winch. Four complete turtles and four dig all the snow out from under the Jeep.

 

[Andy-WhiteTJ]

Went back up Patterson Mt Rd.

Debeaded a tire. Cooked another M8000 winch motor. Warranty replacements are good for two or three pulls and smoke. Glad I bought recovery boards...ended up digging myself out of a hard turtle... completely under the Jeep...four times and using the boards to launch me down the trail.


View attachment 416975

View attachment 416968

Maybe you need a snatch block or two and double or triple the line pull. Just saying...

 

[macleanflood]

Maybe you need a snatch block or two and double or triple the line pull. Just saying...

Was careful to do first or second layer pulls and observe duty cycles. I have three rings... probably right that I could have rigged straps and pulleys for a double or triple line pull. Also was using traction boards as ramps...pulling the Jeep up the ramp instead of into a pile of snow.

All good advice!

-Mac

 

[Cbrianroll]

Found out the nut bracket is bent, it was stripped too….previous owner stuff is fun to fix. Guess it’s new wind shield frame time….unless I take the hinge off, cut a hole, weld it up? Sounds like a lot of work lol

 

[Longwhitejeep]

Finished slider install and quick run around the block. Wheeling trip this weekend after a work trip to LA/SF. Red eye back Thursday night then pack and leave Friday afternoon. Going to be a wild week.

After this trip, a tear down begins for some long awaited upgrades.

 

[chudlet]

Buttoned up the lift install on the rear end this weekend. Just need to set the pinion angle and order up a drive line. Won't be mistaken for a drag car, but sure has the rake.

 

[voodooridr]

Buttoned up the lift install on the rear end this weekend. Just need to set the pinion angle and order up a drive line. Won't be mistaken for a drag car, but sure has the rake.


View attachment 417253

Needs 37's

 

[chudlet]

Needs 37's

You sir, are an "enabler".

 

[NJW]

Flew to Vegas to pick this up -

2 hrs into a 10hr drive home. So far, so good.
Made a pit stop for lunch.

 

[RINC]

Flew to Vegas to pick this up -

View attachment 417296

2 hrs into a 10hr drive home. So far, so good.
Made a pit stop for lunch.

View attachment 417297

You are not my favorite person right now.

 

[Apparition]

You are not my favorite person right now.

You jealous of his matching hood?

 

[RINC]

You jealous of his matching hood?

Fucker?!!