Novak Conversions Jeep Wrangler TJ engine mounts

OG LJ

DoOver

TJ Enthusiast
Original poster
Supporting Member
Joined
Jun 2, 2020
Messages
412
Location
So Cal
My new ride:


IMG_3925.jpeg


Not a TJ. I enjoyed the knowledge and wheeling with a few on this site when I had my LJ so, I hope I don’t get banned for this one…
Quick run down:
1975 Jeep
Throttle down custom's frame
Aqualu body
LS from a 2006 Tahoe
4l80 trans with Atlas
Dana 60 rear
Boat anchor Dana 30/44 front

Just picked it up Friday. It’s a running, driving project. ECU needs flashed. Tires need balanced. Heater & A/C need installed. Like all Jeep’s, I will pick away at the project list.
 
Man, that thing looks looong.

Definitely longer than my LJ. Current wheelbase is 108. About the same as my LJ. Plans are new front axle stretched a few inches with 40’s.
 
In need of a new set of rotors. Front axle is a Dana 30 with Dana 44 hub. The rotor from an 86 K10 will fit but, I need it redrilled to 5 x 5. Anyone know where I can purchase those?
 
I think your best bet will be to take measurements from your current rotor and see if you can match it to something online or in store.
 
Novak Conversions Jeep Wrangler TJ engine mounts