SOLD Dana 30/Dana 44 built axles

[Jamesval035]

Price

5000 *pending*

Location

Cameron, NC

How goes it everybody. I will be pulling my axles to replace with JL axles and all items for the suspension in late December.

Fully built axles off a Jeep TJ with the below:

- 4.88 gears, ARB lockers front and rear Dana 44/Dana 30 w/ compressor and switches
- Chromoly rear shafts Yukon 35spline
- Front rcv shafts 27 spline, I have new orange boots and one rebuild kit to go with it.

All work was done by ECGS near Durham, NC in 2019. I have probably put 15-20k miles on the axles since the build and still work to perfection.
Will come with:
- Currie rear trackbar w/ relocation bracket
- rebuilt rear drums about 5k ago.
- rear tom woods drive shaft (can’t remember the length)
- Currie front trackbar
- Currie steering setup
- Savvy off-road aluminum control arms double adjustable
- black magic brakes (BMB) 16” big brake kit
- Savvy off-road gas tank skid
- front tom woods drive shaft (stock TJ length)
- JKS 3” springs
- JKS front shocks and rancho rear shocks
- JKS bumpstops
- Barnett Dana 30 diff cover

All items other than the axles probably have 5-10k. Does have surface rust on the axles and embedded dirt but deep real rust.

I am trying to sell everything together but if come December I get no takers, then I’ll separate everything.

Looking to get $5k

View attachment 656296

View attachment 656297

View attachment 656298

View attachment 656299

View attachment 656300

View attachment 656301

View attachment 656302

View attachment 656303

View attachment 656304

View attachment 656305

View attachment 656306

View attachment 656307

 

[CodyP]

PM sent

 

[Paparock1]

if the pending falls through and if you decide to separate and the gearing is 4.56. I would be interested in the front axle.

 

[Jamesval035]

if the pending falls through and if you decide to separate and the gearing is 4.56. I would be interested in the front axle.

Just realized I forgot to post the gear ratio, they are 4.88’s