axles

New Wrangler TJ owner here. I need help determining what axle type I have. It is a 2005 Wrangler X I did do some research and found that they are most likely Dana 30's but I just want to make sure. Also, what are your suggestions on getting heavier duty axles for off-roading? I've read that the...

The factory Dana 35 rear axle found in most TJ Wranglers is a little on the light side, and if you run larger-than-stock tires, you’re likely looking at an eventual failure. If you want to turn really big tires, wheel abusively, or push gobs of power into your rear axle, you’ll probably want to...

hey guys i have a couple spare axles laying around and thought someone else may be able to use them. i just want to get rid of them now so i'll let them go for $120 a piece preferably to a local buyer (Bozeman MT) so i dont need to deal with shipping but if you're willing to pay shipping i can...

who makes the best shafts for the money? I dont have $1000+ for shafts for a front ford hp44 but i need stronger than stock shafts so who makes the best affordable chromoly 30 spline shafts?

So one of my axle joints is wore plumb out. Now I'm reaching our to you guys for some help. I know how to replace them kinda but looking for a helping hand in how to make it easier and some guidence. All help is apreciated. Thanks in advance.

Just saw this...... http://www.jeepforum.com/forum/f127/2006-rubicon-dana-44-front-rear-axles-pumps-3573658/

If one was to go with aftermarket axles (let's say built high pinion D44s or possibly D60s) what are the best companies to choose from? I know of Currie and Dynatrac, but are there others? In addition to that, do any of these companies have a better reputation than others? I know Currie is top...

In contemplating going to 35" tires. I've got an 06 Rubicon with Revolution gears, factory lockers, RCV front axles and Revolution chromoly rear axles. I guess that counts as Super 44s, right? Anyways, would I be safe to run 35" tires and wheeling it as well? I don't want to do it if it's...

While this write-up takes place on a Dana 30 front axle, the procedure should be nearly identical for a Dana 35 or Dana 44 axle as well. If you're mechanically inclined this isn't that bad of a job in all honesty. Just take your time, be patient and take breaks when needed (it always helps to...

How many splines (both inner and outer) are the front axles on a TJ Rubicon? Not sure if it's 27 or 30...

Ugh... One of my orange CV boots on my RCV axle keeps popping off. I get it on all the way (I think I do at least) and then I go driving and it pops off. What exactly holds these boots in place? Just the pressure alone? This shouldn't be as hard as I'm making it out to be, but I'm stumped as...

okay, i can't imagine his axles like him for this one...