Search results

If you want to pay way too much for a rough looking one.... https://ebay.us/m/nd32uk

Also consider taking the time to pull the entire harness and do the repair on the bench. It is going to be a pain in the ass trying to work on it still attached. If the loom is in rough shape it would be a good time to redo it as well.

Yes I had to use the extension cables. The ones for the 35" tires are almost too long for the JL so you need to play around with crossing them. I bought them from the same retailer at the time I bought the rack. You could easily make some up with basic cable and crimps. These are the exact...

It is 10" from the back to the front.

I sometimes put it on my Jeep JL as well. I need to remove the camera cover and put shims to push it out an inch. I've done pretty long road trips that way and it doesn't move an inch.

Look for a 1992 or later XJ. The earlier models had a vacuum disconnect which you don't want. The Jeep Cherokee XJ models from 1990 and earlier, and some early 1991 models, were equipped with a vacuum disconnect front axle. Specifically, this was a Dana 30 high-pinion front axle with a...

I rekeyed with a wafer kit I bought off ebay. You will still need to get the cap from a locksmith. I then disconnected the arm inside the runs to the inside latch. I can lock my doors and even when topless you can’t get the doors off unless you unlock them with the key.

Not mine but it looks like a good deal for someone.

Call Garys Auto Recycling in Maple Ridge. If they have one I will pick it up and mail it to you.

I don't know the answer to your question but if you need any LJ measurements or details on how I installed my bench let me know.

Any feedback on these @mrblaine. I'm building up my list to redo my harness.

Here is the one Blaine sells. Probably what you heard people talking about. https://blackmagicbrakes.com/ols/products/johnny-joint-washers-set-of-4

@NovakConversions might have an answer. They are active on the forum.

https://wranglertjforum.com/threads/fuel-brake-line-fasteners.33962/

Or find someone with a 3d printer to print up a case. I am sure there are lots of free designs based in standard proto board sizes.

For my steering wheel control project, I first used an Arduino on a custom board with a voltage regulator. I couldn’t get the Arduino analog to digital pins working properly since the Jeep voltage fluctuated so much. I still don’t know if it was an issue with the Arduino or my circuit design...

Rubicon Lockers

Looks like a WJ steering wheel. You can see this thread here, pay attention to the last few comments regarding how the clockspring fits in. https://wranglertjforum.com/threads/new-leather-steering-wheel-from-poland.35616/