Recent content by Tom Jensen

Bret, i just got done fixing the rollover valve in my 2005 tj. I had to drop the gas tank & sand off the 3 sets of ridges. Not an easy job but its done & filling up is back to normal. TJ

I recently replaced the fill neck assembly on my 2005 TJ but the gas valve keeps kicking off when filling. I had to cut the hose (length) that runs from the new filler neck to the gas tank to eliminate a big kink. I have reduced the size of the kink drastically but I don't think the smaller...

I want to obtain a little more power on an initial acceleration and going up hills. By replacing the 55mm throttle body with a 62mm bore throttle body, will that accomplish that? Is there any other suggestions out there without spending a significant amount of money. Can the PCM be programmed...

Hill, purchase a code reader. They are inexpensive. What you can't see, the codes will tell you what is really wrong with your TJ.

Chris, I am glad you recommended Wrangler Fix to me. They did a great job fixing the circuitry within the ECM. Thanks Again. Tom Jensen

Mark, I am glad I sent you my ECM to fix. So far after 2 weeks the faulty O2 sensor indication has not shown up. You did a great job fixing the circuitry within the unit. I will recommend your company to other folks. Tom Jensen

Chris, I P0032, P00338, P03352 & P0058

Folks, After replacing all the O2 sensors, I am still getting 4 alert codes indicating High Control. The resistance for each sensor is good. It looks like the problem could be in the ECU. I'm wondering if anyone agrees and if so what should I do. Can I send the ECU out to be...

I found what you suggested on line and purchased the set. Looks like an exact replacement. Thanks. Tom

No your good. I found the entire unit on line and as you stated, it was inexpensive. Thanks , Tom

About a week ago I posted about my headlights on my 2005 TJ whether in low or high beam the blue light on the dash would always be lit. That has been fixed. After installing new headlights the adjustment screws to adjust the beams left to right or up & down, the torx part of every screw is...

Jerry, those wire colors are not at the headlights. The colors above must be for a different year then 2005. The yel/wh and Wh/yel are. The diagram above that you sent me is that looking at the rear of the connector where the wires enter? Is #3 on the plug ground/black because on mine the...

Jerry, Yes. I knew the bottom was ground or #3 but if you are looking at the back of the connector, is #2 the right pin and #1 is the left?

Jerry, I know those wires very well. I had to replace the old 3 pin connectors with new ones and they did not have have the numbers 1, 2, or 3 on them. Do you know which pin goes with the proper color wire. Obviously, ground is the middle one but maybe I mixed up the #2 and #3 pins. That...