Recent content by TimC

Sorry it a 2006, 4.0 Sport

Before I go out and start poking around with a meter, are the spare fuses located behind the glove compartment, on with the key, full time power, is there any wiring harness already hooked to those fuses? Thanks Tim C

@MikekiM Thanks, that is what I was hoping to find when I started down this road, Thanks for the offer of the parts, but I'm going to play it safe and get one that comes with the factory harness. I'm not that confident in my wire-building skills. Tim C

MikeKim double DIN Auto Dim, Ambient Temp & Compass Mirror Tell me more. TC

Affordable is in the 100$ range I have found some that might work but they were in the 3 to 500$ range. To rich for me to buy to see if it would fit. I’m trying to fit a outside temp gage and compass in a standard three gage pod I have a RitchieSport x-23 and that would work but it is to long to...

Any recommendations for an aftermarket compass? I’m trying to find something that will fit in a standard 2-inch gage pod. I’ve been searching the internet and I can’t find any that's affordable anyway. I brought a RitchieSport marine compass but it is going to take a lot of adapting to get it to...

I got ya DRPayne I used a cheep ass connector to reconnect the wires because it was what I had in the shop now I’m paying for it, but wanted it back on the road. Thanks CharlesHS I’m definitely putting that link in my favorites.

Thanks the plug at the tank is what I’m looking for, it’s a bit pricey but they kind of got ya, I can’t find one anywhere else. Tim C

I’m trying to find a factory replacement wiring harness for the fuel pump for a 2006 TJ, I had to cut it to be able to drop the tank. I have already spliced in a plug but looks like I might need to replace that plug and I don’t think I’m going to have enough wire. Would like to have a new...

How did this workout? I’m trying to restore the khaki color to my fender flairs. Thanks

I’m thinking’s about removing the factory box tail lights to some inset ones, I’m sure someone here has changed their tail lights to be inset in the body, how about some pictures, suggestions, or pointers.

The rust isn’t bad just some surface rust on the mount itself, nothing some sand paper and a rattle can can’t fix.

I looked at that wasn’t sure if those would just unplug or not thanks.

I need to remove the factory stair tire mount to deal with some rust, so I don’t get frustrated and just start cutting wires, is there a trick to getting the brake light wire pulled through? Thanks Tim C

What are the brackets in the picture for? I'm assuming number one is just a tie-down for whatever is needed. Number two looks like it was meant for a specific purpose. Thanks