Recent content by Stump

Maybe I shoulda cleaned my bolts.

Well, here they are, and they are everything that I wanted them to be. I went to the Corbeau shop yesterday. They had what I wanted in stock. Being able to sit in each seat I was considering made it a no brainer for me. They said they could have the seat heaters and driver side lumbar support...

Really? That’s a huge disappointment considering the cost and that I have been relatively happy with the fairly cheap Bestops in the past. Anyone else, good or bad?

Yeah, I didn’t read far enough. I saw that. 😞

I have definitely thought about that. About 20 years ago I tossed some Bestop seats in a YJ I had. That was an awesome improvement. Where I was disappointed was that I like to be really rucked into the seat. I do want a completely different style of seat that wraps around me, but still reclines...

Looks like a lot of people already said so, but here is another plug for PCM and Wranglerfix. Here’s the link to my story. What I didn’t really say was that my original problem, about a year before all this, was occasional engine shutdowns. Key off then back on usually fixed it. I swapped out...

So, I want some decent seats for my TJ. My seat is a bit worn on the driver side of the driver seat, if that makes sense. I usually drive with the doors off, giving me a little lean out the door. As I was looking for a place to go sit in some seats. It turns out that Corbeau is just about a 15...

Thank you. The crankshaft code was legit. As I started troubleshooting before I replaced the PCM, I found that the OPDA was loose, causing a cam/crank disagree code. The 0300 random misfire code hasn’t been a problem since changing the PCM. I did check the security and integrity of the sensor. I...

About five days and a couple hundred miles. A little dirt time. Still going strong.

Thanks!!!! The one I submitted was after the sun was lower and through the roll bars.

Hopefully this story helps someone else. I started having some electrical problems with my 2005 Sport with a 6 speed. I started getting an intermittent no crank situation. Jumping the starter would crank it, but no spark. I also noticed that my OPDA was a little loose, and it caused a crank/cam...