Recent content by Schwifty Rich

Son of a gun, looks like I’ll have to try my hand at locating a used parts locker. Any chance anyone has a lead? Daveys has nothing from what I saw 🙁 I’ve been searching around and read that I could also throw a front locker in there. Thoughts?

Hey howdy hi everyone, I’m elbow deep in a ring and pinion replacement and noticed some odd wear on my short axle shaft and checked the inside of my carrier to find the teeth all mucked up. It looks like it got loose some how and had too much play. The long side is undamaged. I just cut off...

Not sure how the drum brakes work, but I would make new hard lines if I were you. I know my rear brake hoses and hard lines come from the factory as one piece so if I ever want to replace the hose I’ll have to make new hard lines and connect it to new brake hoses.

so much has happened since January! I recently began to tackle some pretty big things on the jeep. 1st, I had to replace my pre cats as one of them was shot and throwing a code. Getting them off wasn’t so hard, but getting the new ones back on was such a pain. I can’t imagine how some people do...

Thanks for the confirmation! So I have been practicing my flares with the hand tool you can rent from the auto parts store and I got one fairly good bubble flare but my double flares are lacking. I went out of my way to rent the same tool from 4 different stores trying to find a quality one...

2003 Rubicon TL;DR [rounded a brake line fitting and it seems the old is bigger than 3/16. can I still use 3/16 or should I try to match the previous size? Help on identifying it? Also any help with fitting identification/verification is appreciated] So in the process of doing a brake job (...

Sorry ! I started a big project! Doing the rear main seal and my exhaust! I’ll send my info!

Edit: I miss read the post. Sorry!

Haha hard to say, but I don’t have a hard top, only this soft top that is as old as the Jeep and definitely has seen better days. But he replied first so I’ll leave it up to him.

I’m a poor paramedic student and my soft top is all busted up. The plastic L’s on the driver side are busted up too. If tom doesn’t take it, I’d like it!

Still plan on doing that compression test so I’ll double check them then. drove a couple hundred miles and broke 100,000 miles with no CEL so I’ve my fingers crossed still.

Installed a new battery, the Optima group 34 agm red top so I feel better about that atleast. I ran to the store today to rent the tools for a compression test and picked up a noid light kit too while I was at it. When I ran the codes again all that was showing was P0340 which is the camshaft...

I am not sure what the actual cold crank amperage was unfortunately. As I wait for the part to arrive I’ve done a little more research. I’m starting to think I have a leak somewhere, be it vacuum or gasket related. I don’t have much experience with engine related issues so this article helps me...

I can’t get it to go in slow motion but rest assured that I’m slow mo, they are all firing in sync. also to update I just got back from the auto parts store and the battery is kinda failing he said (cold it had 12.9v) but the alternator was good. Found this sensor I’m going to buy and see if...