Recent content by Grumpy’s Rubi

Bartact covers , buy once, cry once

Finally got the time to do just the simple toggle switch mod for independent locker control. While testing my connections in a quite garage I discovered my front locker pump is just clicking and not pumping, on the good side the rear is good!! As @PRNDL stated you can take the OEM locker switch...

Amazon had em on sale a while back

Did you put separate switches in and remove your OEM switch by any chance? Or did the bypass of the interlock only and add a master switch?

@PRNDL I’m back at my locker by-Pass project and was wondering if I run the separate locker switches can I pull my OEM locker switch out and repurpose that spot. All I have read is everyone has left the switch in place to fill the slot. I plan on doing the simple toggle switch with cover only...

Thanks, the PO had the amp wire pulled through under the master cylinder so I’ll go through by the heater hoses. Gotta pick up aux trigger source from fuse panel anyway. Good info on leaving a pull wire in place.

@MikekiM thanks for the note tag and that’s the orientation I did tonight. You mentioned a location under the cowling to route the control cable in to the jeep? I have the switch panel above the dash vents so need to finger that out next.

Wondering if MikekiM might share where you located the main breaker (60 amp) for the control box? I am going to use the support rod for the box but don’t want the breaker loose.

Thanks, I tried it as I stated and was getting a small voltage even when the switches were off. I tried some various ways with some jumpers I made even used different switches but was not happy with em so went back together with the factory switch and a jumper between 4&5. Works as it should. I...

I have a 06 Rubicon that I’m looking at doing the locker bypass on, I understand the jumper between pin 1,4&5. I want to install OEM style diff lock switches which I have but every forum and post are adding to OEM switch or as Jerry did running new wires. I’m trying to tap into the OEM wiring...

Finally got a picture of mine with them installed. Yes that’s the view from behind….plenty of light. Thanks!!