W
wkelley70
Member 55 From Eagle, ID
- Messages
- 47
- Reaction score
- 21
- Joined
- Last seen
- Viewing thread Wells Vehicle Electronics (WVE) Multi-function Switch & Connector
Latest activity Postings Attachments Images About
-
-
Wwkelley70 reacted to sierradmax's post in the thread STICKY Share Your 3D Design Files (or Sell a DIY Part) with
Like.
If anyone is rebuilding a Saginaw steering box, I found some 100mm ring clamps and scaled them to 2.75" & 2.00", the sizes needed to... -
WMods - If this isn't the right forum, please move or delete/ I recently stumbled across this video and thought it really explained the...
-
Wwkelley70 reacted to sab's post in the thread A Comparison of the OEM 05-06 OPDA to the Crown Aftermarket Version with Like.
I recently decided I wanted an oil pump priming tool, and I figured the best way to make one would be to use a castaway OEM OPDA. I...
-
Wwkelley70 reacted to jscherb's post in the thread Review: Auxbeam slim switch panel systems with Like.
Auxbeam Slim Switch Panel Systems AS-400, AS-600 and AS-800 Auxbeam has been a major player in the switch panel market for quite a...
-
WWelp, so much for SKF now I suppose. Pick your made in China unit bearing that you like best...
-
Wwkelley70 reacted to JCaspary's post in the thread STICKY Share Your 3D Design Files (or Sell a DIY Part) with Like.
Here are some .STL files for center vents. These are meant to match up as close as possible to the OEM ones. I have yet to finish...
-
WThe FSM has a section on replacing the bearings, how to read the factory paint codes on the crank (if still present), etc. Download...
-
WI’ve always used 400 grit emory cloth to polish cranks. https://www.amazon.com/dp/B005TQ2RY2?tag=wranglerorg-20
-
WGet and use Plastigage for which bearing size to use. It depends on how much clearance is there. Going undersize without checking may be...
-
Wwkelley70 replied to the thread Advice needed on rear main bearing.New main bearings are inbound. I would like to polish the journals as well. From the picture below you can see the "etched" surface...
-
-
Wwkelley70 reacted to macleanflood's post in the thread Advice needed on rear main bearing with Like.
I'd find the numbers on the bearings and order accordingly. Note that I've rarely seen a randomly different sized bearing in an engine...
-
WConsidering your mileage and the condition of the other bearings, I would recommend replacing all of them. That way you know when they...
-
WWhile replacing the rear main seal on my 2006 LJ with 4.0 engine i discovered that the PO got RTV on the main cap on places it should...
-
WI'm running the ECGS in their Dana 489 axles with 37's and had good luck so far. I'm not easy on them at all.
-
WI've been running the ECGS axle shafts for my TJ Rubi Dana 44's for a while now on 35's... and I'm not easy on them. No issues so far.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
