Latest activity Postings Images About
-
-
k1n3k replied to the thread Parts list for a TDI swap.Alright, you're going down the same line of thought I did with my builds. I needed more range and more power. the poor little 1.3L 4... -
-
k1n3k replied to the thread Parts list for a TDI swap.I've done an ALH swap into a Samurai in the last few years and was looking to do it in my Jeep next. First off, I'd go with a CJAA or...
-
Anyone who hasn't hurried to catch a flight amid fighting off dysentery makes me question if they are even alive or just passing through...
-
k1n3k replied to the thread What have you 3D printed for your TJ?.If you did, would your winch then match your Jeep? 🤔
-
Can anyone advise me as to what the three vertical hole positions on this plow mount are used for . Thanks
-
k1n3k replied to the thread Engine sputters when turning on high beams.Just a dumb idea, but get the thing back up to operating temp, then take your garden hose or a water bottle or whatever and spray the...
-
k1n3k replied to the thread Fire Extinguisher Rabbit Hole.The other problem you'd run in to is its not always just your rig in the engine bay that you're going to need to put out. It might be a...
-
Barefoot. Don't forget barefoot. I'm pretty new to 3D printing. Other than thinking the name is kind of dumb, the tech is amazing! I...
-
k1n3k reacted to mrblaine's post in the thread RockJock CurrectLync steering system worn out after only 1.5 years with
Like.
Do you have any idea what is under the steel cap with the grease fitting screwed into it? -
k1n3k replied to the thread What have you 3D printed for your TJ?.Its pretty mind blowing how far its come in the last 3-4 years. The first printer I owned was one I built from scratch on another 3d...
-
-
k1n3k replied to the thread All Known Speaker Enclosure / Pod & Adapter Options.I'll have to take a look once I get that far tomorrow. I need to run power still, and validate my cables are long enough from the...
-
k1n3k replied to the thread All Known Speaker Enclosure / Pod & Adapter Options.I thought I recognized the username! I'm actually pretty please with the design so far, at least for the sub mount. I've not looked too...
-
k1n3k replied to the thread All Known Speaker Enclosure / Pod & Adapter Options.Found a mount you can 3d print to replace the factory sub with the JBL BassPro and a midland radio in the console. Kinda neat, I'll be...
-
k1n3k replied to the thread What have you 3D printed for your TJ?.Any reason it needs to be printed in that fairly flat orientation? I'd set it up on the back edge and print it vertically if its only...
-
k1n3k replied to the thread What have you 3D printed for your TJ?.This is the stuff I've been using: https://www.amazon.com/dp/B0CKW2896L?tag=wranglerorg-20 I just tell the printer its the Bambu ASA-CF...
-
-
Loading…
-
Loading…
-
Loading…
