yukon

Placing this post as pending,I have someone that might buy my whole lot of D44s and other Dana 44 parts that will come (didn't post pics of those parts) so for the next few weeks it will be pending as the potential buyer isn't around town I'd rather sell everything at a cheaper "wholesale" like...

I'm new to the forum, so I apologize in advance if this isn't where to post this. I'm looking for some opinions on this pattern I just ran. I'm regearing my LJ to 4.88 yukon gears and installing an ARB locker in the rear. The pictures attached have the latest patterns i just got and below are...

I have a guy wanting to sell me a dana44 rear from an '05, a new set of Yukon 4.88s for 30/44, and an Eaton Detroit trutrac for the 44. 1600 and a 6 pack...is this a good deal? Should I pull the trigger? I was planning on doing a super35, as I don't do any aggressive offroading, mostly just...

Hi all, Picture attached but due to a shortage of spicer 709644x ball joints, went with the Yukon ones, but to my surprise the lower joint had a Zerk fitting…in a test fit with just sliding the axle in, it looks like it either just barely clears or just barely hits, so my question is do I...

The Yukon Super 88 Kit will allow you to eliminate the c-clips and upgrades the axles to a 4340 chomoly, and are drilled for 5 x 4.5 or 5 x 5.5 pattern. Installation is pretty basic, no special tools are needed, except one thing. You will need a shop press and I just happen to purchase one for...

There are two hub kits available for the Dana 30 from Yukon, the WU-07 and WU-08. Both are pretty spendy, 07 being just less than $1000, and the 08 right at $1450. I chose the 08 feeling it was a bit more robust hub unit, with the 07 being very similar to old Bronco II hub units. I have no real...

Yukon Gear & Axle (YG Dana 44-488T-RUB) High Performance Ring & Pinion Gear Set for Jeep TJ Rubicon Dana44 Differential. Yukon Gear & Axle (YK Dana 44-RUBICON) Master Overhaul Kit for Jeep TJ Rubicon Dana 44 Differential . 488 gears. Rear New still in box. $350 For pictures look here...

Oh, look, another LS conversion in a TJ. :rolleyes: Yes, this thread is about another conversion, but I hope to alleviate and answer alot of confusion and offer some answers or advice. The goal with "Sarah" is to have a capable DD that can be very capable on the weekend. This project has...

2006 Jeep Wrangler TJ with 80k miles. Color: Black Engine: 4.0L I6 Trans: Automatic Front Axle: Dana 30 Rear Axle: Dana 44 Upgrades: * Rubicon Express 4.5" long-arm lift (plus 1" spring spacers) * BFG 35" Mud-Terrain KM2s on 15" Mickey Thompson wheels (tires purchased in last year) * ARB rear...

Well? This is my angle; In a Dana 30 HP front would you do the Grizzly so you could run 30 spline axles or choose the Detroit and run 27's? Power will go through Spyntec 1/2 ton Chevy outers. Thanks!