track bar bracket

Hi All, I have seen this brought up in various threads but I’m still not clear on whether I need a relocation bracket, adjustable control arm, or both in the rear. I have a 2006 Rubicon, 2.5 inch OME lift, tummy tuck, and DC rear driveshaft. All 8 control arms are Teraflex short arm. Running...

Adjustable font track bar, new heim joint, frame side drop bracket, with matching XJ pitman arm. Ran this set up for last few years with no issues, bracket and pitman arm match. Replaced heim joint (less than 50 miles), ended up upgrading to Rockjock. Make an offer, prefer local pick up.

Ok so I just installed a new track bar and track bar bracket in the Jeep. I have a teraflex high steer setup and a rough country drop pitman arm. I am not trying to get into a debate about having a drop pitman or not or what you think about RE track bars and there brackets or any other brands. I...

So I've got to replace my bent trackbar. I ordered a JKS OGS125 Adjustable Track Bar. Problem is I forgot I had to drill out the frame side upper track bar hole to 5/8 for the bent track bar and the new one has a 9/16 bolt. Is there some kind of bracket I can get to adapt this? I've seen...

Frame side mount is wallowed out. Need a tapered sleeve for a temporary fix. Any ideas?

Good Evening, I purchased my first TJ a couple weeks ago, and it has an annoying amount of steering wander at 50 plus. I had some work done to it to try and resolve this, and it's a little better but still very uncomfortable over 50. Recently done: -Tie Rod Ends (Inner and Outer) -Ball...

So as I was reading through some topics trackbar relocation brackets seem to be a hot issue among some. I was looking at mine because I knew it had one and I just wondered if there was anything wrong with having it as it moves the track bar further forward to clear the diff better as far as I...

Relocation Bracket as pictured. Requires welding the tabs at the bottom where they fit against axle shaft housing. Only mounted for a few days but never welded and then I went with a JKS kit because I had to order the bar and bracket sold together. Measurement shown for the track bar mount...

FS brand new OME rear track bar relocation bracket. Never used. Was going to use with my 2” lift but ended up using the JKS angled bracket to go along with a SYE. $25 shipped

Installed an Iron Rock Offroad 4" lift kit. Came with a front track bar relocation bracket. Instead with supplied bolts but few this is causing death wobble. Was considering welding the bracket instead of the bolts. Thoughts?

I'm running this with my Currie 4" lift: http://www.currieenterprises.com/cestore/Product.aspx?id=3796 My question is, can the lower portion of it (the part that's supposed to be welded to the axle tube) be welded on while the axle is still in the tube and everything? I'm asking because I don't...