tj

Located in KC. Specifically Olathe. $50 takes it. It’s dusty but basically unused.I will include the mounting brackets from the front mounts but not the rear. No rips or tears and cushions are like new. I’ll list it on FB Marketplace Monday.

Hi all, I have this wierd issue I haven't run across. Just finished rebuilding my 4.0 with 0630 head, bored 20 over and Installed stage one cam. When inspecting block and head for cracks after back from.machine shop I didn't notice the bolt holes for the exhaust/ intake run through on any. It...

For any GBBS fans out there, the theme of the week is electrical problems in my garage (for my LX470, my TJ,). I am stumped on this one. Symptoms started like this: Initially, one fog light went out, and a bulb replacement did not solve the issue (this was 4-6 months ago). Then about 1 month...

Urban 3D started with a focus on 3D printing, and has since grown as a dealer for almost all brands available to be a “one stop shop” for anyone building buggies and crawlers. We also work closely with Huffman’s Fab to bring fab housings to everyone. One of our more popular 3D printed parts has...

Currently wrestling with a silly little TJ. (97) Had O2 sensor codes and rough idle with loss of power before engine reached “closed loop” temps. Replaced O2 sensors (with the ones recommended by the updated O2 sensor thread) and it ran fine. Drove about 1800 miles then bang O2 codes again...

This thing is driving me nuts. My symptoms are a low/rough idle (sometimes sounds like it’s about to die). Also occasionally while driving usually happens around 2.5-3k rpm with about 1/4 throttle it starts stuttering/jerking very badly and if I let off gas or floor it, it quits. I have...

I revived an old thread about transmission mounts but before I start spending money I want to make sure I'm chasing the correct problem. I have an 04' Rubi with the 5 speed NV3550. Rock Krawler long arm kit and skid from PO so not sure what else is stock and whats not. Whenever I hit a big...

Excellent condition Hard Top with both the rear wiper and defrost. Just installed new gas-struts for holding the rear window open. I'll include both the stainless bolts I currently have installed plus new set "quick remove" thumb screw attachment hardware.

Hey all, I have an 02 Jeep TJ automatic giving me some trouble for a few months. Started about 2-3 months ago when I randomly felt stuttering/misfiring-ish when coming to a stop at a light or stop sign, and it would remain as I initially hit the gas to get going again until I got the speed up...

I'm new to the forum, so I apologize in advance if this isn't where to post this. I'm looking for some opinions on this pattern I just ran. I'm regearing my LJ to 4.88 yukon gears and installing an ARB locker in the rear. The pictures attached have the latest patterns i just got and below are...

No off-roading opportunities, no one to cruise with. 1997 TJ, 4.0, 5 spd, 296,000 miles. 8,000 lb. Warn Zenon 8-S winch, BFG K0 2 33 x 10.50 x 15 tires have about 5,000 miles on them (just rotated), New front wheel bearings last 500 miles. Full top, full doors. Mastertop Bimini top, Wind...

Set of 5 OEM rims taken off my 2004 TJ Rubicon. $250 Local Pickup in the central Ohio, Columbus area.

Hey all! I'm looking for a cheap car to use this summer bombing around to the beach/hiking trails, nothing too crazy. I saw an ad for a $3000 1998 Jeep Wrangler TJ. I know these cars can be pretty sought after, so the relatively cheap price is scaring me. The ad says all is working fine and...

I am having some confusion on why my LJ is not closer to level from driver side to passenger side. Driver front is roughly 1.5”inches higher than passenger. 2.5” suspension lift was installed, springs were same size (made sure beforehand). I also put myself in the driver seat and had my wife...

Howdy, seen plenty of threads on here about cats, and the usual answer is Walker or Magnaflow. Welp, I have a 2001 4.0 I've been working on, and I just took off the cats cause I'm replacing the exhaust mani and oil pan / rear main seal. Aaand the cats look to be some weird aftermarket ones...

My Jeep Wrangler LJ Rubicon’s rear differential carrier is damaged (locked and won’t unlock from the limited-slip gears). Can you recommend a place where I can get a replacement carrier or possibly upgrade ?

Currently have green coolant in my TJ and not sure what was put into it, thinking of using Zerex Original green, has anyone used it before, or have other recommendations?

I have been looking at custom fabricating a roof rack for my 2005 Jeep TJ, however I do not know where to mount it in the rear. in the front I am going to mount it to the windshield hinges, but in the rear I am struggling to find a good spot to mount it. I was thinking to the frame behind the...

I have an 02 jeep tj. It is a 4 cylinder and an automatic transmission. When I bought the jeep it had a code for an evap leak. I tried replacing gas cap, but it did not go away. Since then the motor locked up and has had a reman engine dropped in it. When I got it back the evap code was gone. On...

I have an automatic 2002 jeep tj. It is a 4 cylinder. I had to get a new engine at 80,000 miles because mine locked up. I am in the break in process of my reman engine and have run into some problems that I am not sure how to address. It may not be a big deal, but I am a little paranoid due to...