np241

Hey all, I’m trying to future-proof some upgrades on my ’05 TJ and could use some thoughts. Current setup: 2005 TJ 4” Savvy lift on 35s Rear: Super Dana 35 w/ chromoly shafts Front: Dana 30 w/ chromoly shafts Driveshafts: Adams 1310 double cardan front and rear Current Project: I’m swapping...

Noticed a couple of drips of what looks like ATF on my driveway. Being that I have a manual rubicon, my guess is that it's coming from the transfer case. Would these pictures appear to line up with a failing transfer case rear output shaft seal? It slung atf all over half the muffler and the...

After replacing the axle side U joint in my driveshaft, I went down a rabbit hole trying to chase down a pretty substantial vibration that occurs at about 65mph. It's bad enough that it makes the change in my cupholder buzz. At first, I thought it was my driveshaft, but after removing the...

Hey everyone, I'm looking to finally swap my np241 out of a TJR into my LJ pretty soon and I'm seeking some opinions from those more experienced. Long story short, i got my hands on a Rubicon transfer case out of a TJR with 240k miles essentially for free. When i drove the jeep i pulled it from...

Hey everyone, this post is semi-related to me last post here. Long story short, i got my hands on a rubicon transfer case for free. When i drove the jeep i pulled it from it shifted smoothly and had no apparent issues. Today i decided to drain the fluid and inspect it before i throw it in my...

I did the 241 swap on my TJ and looking for the harness side of the connector. Anyone have an extra? Do an Atlas swap? Have a buddy’s that you can cut off and ship me? Ha ha.

Rebuilding NP241 or 241OR Transfer Case Pre-work: I have had some noise from what I thought was my rear axle, but actually was coming form my x-fer case. I posted a thread here on the issue. After running the Jeep on stands, there was alot of noise from the case. Not what I really wanted to...

Update: Put axle together last week and still have noise. Today I put it up on stands, and what I thought was coming from axle was coming from my transfer case. Sounds like I need a set of bearings for the case, a rebuild kit. Issue is, who has one, or who has rebuilt one, and where did the...

Rubicrawler for Jeep TJ with NP 231/241 New and has never been installed, comes ready to install. No disappointment with this great component that turns your Jeep TJ into an obstacle monster! Buyer pays for shipping

Oh, look, another LS conversion in a TJ. :rolleyes: Yes, this thread is about another conversion, but I hope to alleviate and answer alot of confusion and offer some answers or advice. The goal with "Sarah" is to have a capable DD that can be very capable on the weekend. This project has...