Search results

I want to see the paternity test on that one🤣

How’s the gas mileage?

https://www.clipsandfasteners.com/Cable-Ties-with-Stud-Mount-Length-160mm-6-p/a25005.htm?gad_source=1&gad_campaignid=22671996361&gbraid=0AAAAAD7kpIwYQWMLGQxnW-QWEjwnjC8Z4

Buy a 4 or 6 man Colman instant up tent. Makes setting up a breeze. The 6 man you can stand up in, not sure about the 4 man. The 6 man is a lot larger folded up than the four man. The 6 man does fit crossways in the Jeep but just barley...

Newer cars will use an oil temp sensor to monitor how fast the oil comes up to temperature as part of the calculation. I would also assume mileage, idle hours and constant driving vs stop and go.

I drilled and tapped the hinge and used flat head screws.

I built one, the bar drops down into a keyhole when opened. Lift up on it to close. It was a challenge to get it into the spot without any welding that would have damages the powder coating. @jscherb your latch looks great.

Fry’s electronics

200 miles may be too small of a radius. When I was looking for my LJ I started with that distance and could not find what I wanted. I lived in Southern California at the time so I started looking for jeeps near enough to fly to and drive back. I found one in phoenix flew out bought it and got...

I have both standard and deep in Sae and Metric. I mainly use the deeps with my impact guns. 1/2” drive. I have deep and shallow 3/8 swivel impacts for use with air ratchets and 3/8” impacts

Yes the two hooks go over the frame then tighten it up to raise the trans mount just off the skid. Makes it much easier

Use penetrating fluid for removal or heat each bolt if you think the will break. Map gas torch works decent. I made a trans support to hold everything up, made life so much easier for doing that task. I ended up building a separate crossmember .

Mac, is that from the tank to the frame rail? It was not clear in any of the descriptions. One way to fix it would be flair the metal tube and use some fuel injection hose with barbed fittings and the correct clamps?

Nice work @mrblaine! Is that a windstar filter box?

Summit racing has the same part

42” are the new 40’s

Not sure where this connects to under the vehicle, might be worth a look...

Most likely a ground problem, check taillight ground and the bulb socket

I have a 14 expensive pos

Is it bump steer or does it seem to drift to the left? If that Fox steering stabilizer is a nitrogen charged one, it will cause a drift to the left.