Search results

I bought a fuel pump from dead jeep a while back and after a few months I needed to prime the pump to get her to start. Figured the regulator was going out. Dropped the tank and replaced the regulator only. Also changed spark plugs they were showing discoloration on one side and had some bluing...

Found this in my local marketplace. What do y’all know about the Jeep Brute? Are they actually made by Jeep? https://www.facebook.com/share/LCGGoFqwKdmWFvYv/?mibextid=79PoIi

When I cold start my tj it beeps and the check gauges light comes on. I took it in to a jeep shop to diagnose some other issues and was told that it is because my oil pressure is low. The gauge on the dash is slow to increase from a cold start. But as the car idles it always sits around 40psi...

My steering is looser than I’d like. I thought maybe I’d need to replace the steering box. Crawled under today to see what it looks like. There is a lot of play in the u-joint that leads into the steering box. The one that is higher up doesn’t move like this one does. Does this need to be...

Trying to locate the source of atf leak. My trans pan for sure. Got a lube locker and new pan this one is bent up. Couldn’t fully remove the skid plate but got it to the side and this is what I am seeing. What do I tackle next?

I did the steering upgrade earlier this year and tried to do my own alignment 😂 it could’ve been worse I guess. Finally took it in for a balance and alignment so I could get a readout. I have a 3” lift. What do I need to do to make my geometry better? Also they said I have excessive play in my...

My airbag light is coming on intermittently when driving straight and turning the wheel left. It beeps once and then turns back off after some time (it varies). My horn and cruise control work. It seems impossible now to find a clock spring for an 01 with cruise control. So is there anything...

Looking for OEM brackets, brackets that will work with OEM Fog lights, or someone who can 3D print them!

Hello Collective Minds I was changing my crankshaft sensor today and found this connector/sensor that is not connected to anything. Any ideas what this would be? The only code I’m throwing for sensors is O2 and I just replaced it today as well.

Ok so I am chasing a possible misfire/long crank situation. And I haven’t seen the condition of the fuel injectors. So took them out and need your wise minds to tell me what’s going on here. Obviously they’re dirty. Not OEM. Some cracks. Some looks burnt/discolored. What causes that? Is that...

Ok so I need a new O2 sensor- as does everyone. But the P0158 just popped: O2 sensor circuit high voltage. Is this a sign I really need to replace the O2 sensor? Is there anything else I should be looking at? P0740 just started for me this week. I have been experiencing a long crank time...

I have a very slow atf leak. Today I found this. What is this hose? Where is it supposed to be connected? I don’t see anywhere obvious it should be in this area.

Hello! I was having issues with my fuel pump priming. PO replaced OEM fuel pump with something crappy. So I got an OEM fuel pump from Dead Jeep and put a new filter on it. I did buy a new regulator, but didn't install because Dead Jeep tested this pump and it's all working fine according to...

I’m back! I replaced my upper coolant hose to repair a leak a while back and everything was great for a few weeks. But doing some work and noticed that I have a new coolant leak. I was hoping it was the lower hose but I think it may be the water pump (assuming I am looking at my water pump 😂)...

Evening All, I am looking for troubleshooting steps to identify a transmission fluid leak. Recently did an atf and filter change. There was a slow leak before and there continues to be a slow leak. It’s dripping down through the skid plate so I need to get that off to see exactly where it’s...

My jeep has been in the garage since I’ve been working in her pretty much since I bought her. Left her outside for the first time and we had a slow steady rain. Found some water in the back after the rain passed. I found drips along the wells and the corners had pretty wet carpet. I also found...

I bought the moog parts on Amazon for the conversion and I am having trouble where the drag link connects to the pitman arm. The bolt on the tie rod end goes into the pitman arm, but it is at the slightest angle and it won’t go all the way through. What do I need to adjust to make it work?

Ok so I am doing the ZJ steering upgrade this week. I managed to get ball joints replaced and the rest of my parts should be in tomorrow. I'm going to do the alignment this weekend - I have 2" lift - do I still to the alignment to 2001 TJ specs? Or what gets changes with the lift? Or do I use ZJ...

My driver side front blinker is working intermittently. Unpon inspection A: has some corrosion inside not sure if it’s a problem but should probably be replaced. B: the clip that holds A on is missing on one side. If we wiggle it about we can get the blinker to work. What are the names for...

So I bought this ball joint kit: https://www.extremeterrain.com/jeep-wrangler-front-upper-and-lower-ball-joints-with-sway-bar-links-psa59722.html And the upper ball joint doesn’t look right. Am I doing something wrong or is this the incorrect part? The lower looks good and sits flush.