Search results

This is a summary video...if you want all the gory details watch the whole Operation Phoenix playlist on my channel. -Mac

Yeah you should be under ten...3 percent is good...32...not so much... -Mac

Went for a drive in the woods... scouting for trash for our non-profit so we can organize volunteer cleanups...this is why I bring a saw... First one I cut. Second one is going to need a least a D9. And yes, 17.5 acres in Oregon 22 minutes from town is awesome. We're right on the edge of the...

Got the initial break in done. It's 19 miles around the lake. Seperate thread on chasing a noise in the front end...turned out it was the rear shaft. So with the rear shaft out it was a perfect opportunity to do a real break in. Starting temp 40.9 to 40.2. Ambient temp is 32. Mileage 249021...

Got a Neapco at Eugene Driveline. Pulled all the caps and added grease. Pumped five squirts into the needle bearing after install. Zero noises. Thanks everyone! Mac

Well I'm probably screwed too! At least I'll get some good videos. -Mac

Yeah it's basically a Chrysler 300 oil cooler. Mine is doing great, but it pulls down the heat in the cab. -Mac

Amazon is telling me two weeks. And I don't trust them to actually send me Spicer. -Mac

Yeah but he's not perfect. Really bad with PPE. Never sets the chain brake. Has a lazy thumb...was watching a video from him about the new 564 and the Husqvarna guy called him out. -Mac

This is for sale right around the corner from me...I literally just drove to the bay area twice to see my parents...but I could ship this down... https://www.facebook.com/share/1DXdgSzztW/ -Mac

I wouldn't condemn an O2 sensor until I looked at live ODB data and voltages. Gross simplification but a "good" O2 sensor typically ranges below.9v. And while you're at it I'd look at your fuel trims and check your fuel pressure. Wonder if you're running lean. You can check live ODB data...

So I called the Springfield store...told them there was one in Corvallis...they hemmed and hawed and said nope... doesn't exist. Called the Corvallis store. Guy went and pulled it off the shelf and then put it on the shelf for the driver tomorrow to bring it to the Springfield store...put my...

Ok so I either need part 211355X which is the greasable version...or...211544X... I called all three part stores in town and nobody has one or can get one. I'll call a couple of driveshaft shops tomorrow. But it looks like a week for shipping. Grr. That or drive to Portland. -Mac

Warn...can sometimes find them used on CL and FB. -Mac

Be careful of replacement shift forks. I had a shop rebuild mine. It went in and out five or six times. On the first lap it wouldn't shift until first. There was a metal spur on the replacement fork that made contact with the case. Tech didn't see it. When they took it apart I watched and...

Yup! -Mac

Grease your needle valves on your driveshaft folks! Don't forget like me! -Mac

Absolutely! Zero argument! My concern is the parallel conductors. All the wires that run next to that wire. The fuse box. The PDC. Possibly the PCM. I've gone through a lot of battery tenders. I've got mowers, tractors, vehicles, motorcycles... they're all mostly cheap crap. When one of those...

Nailed it! Winner! -Mac

And... problem identified! Double carden is shot! I have a spare for my front...I wonder if it's the same... -Mac