Question in regards to placing lower half of rear main seal into bearing cap

Finishing up on plugging my rms/valve cover oil fountain of youth.

Question in regards to placing lower half of seal into bearing cap. Where did you guys applied anaerobic/rtv ?
I see 3 different guides doing 3 different things:

https://wranglertjforum.com/threads/how-to-replace-a-rear-main-seal-on-a-jeep-4-0-engine.27142/
does what service manual says, which is place the seal into bearing cap dry and apply anaerobic around the edges.



https://wranglertjforum.com/threads/rear-main-seal-replacement-4-0.826/
this one does the same thing, but adds anaerobic at the tips in between seal and cap.



This youtuber goes all out with rtv and covers entire bottom edge of the seal that mates with cap.




Sooooo, what the heck did you guys do?

Thanks guys, i did go by the FSM which was like the 1st pic.
And just now realize that there are two different seals for different years.

By the end of sliding the upper seal in, i unintentionally pulled on plastic guide and it fell out. Tried to save the situation with a flathead screw driver, but still managed to make a small cut at the outer edge
Assembled everything back together in hopes that it had no effect on anything... lets just say if i didn't have rms leak before, i sure do have it now