Recent content by TuckerMAustin

Still have the rock sliders?

*Update* Fixed the slipping problem by adjusting the throttle valve cable, easy. Then figured out I had a faulty trans fluid temp sensor. I flushed the lines and checked for tranny pump pressure and it works great. Decided to get a new sensor and it doesn't even get up to 180 now, which is what...

Haha it’s never just a simple fix with these things… I’m going to try a reverse flush in the cooler lines today and then go from there.

Yes, and fluid is still red, it was running at 180-200 a few months ago but now it’s doing 210 consistently.

Installed a temp sensor in my 32RH tranny pan which is a deep pan and also have an auxiliary cooler in line with the stock cooler and it’s running at 210 degrees just driving normal around town. In 4low in the hills, it was reading around 220-240. Is this high? I’ve got ATF+4 in it that’s only...

Hey Jerry, do you mind showing me how you wired your rear locker pump up? I’m not great at understanding wiring and am hoping to do the same thing as you…

It will pump continuously if I connect the pink and green to ground and reds to power

Thanks for the reply. I just have it wired to the battery to test the pump and it’s not pumping. It does a soft pump for a millisecond and quits. Bad pump?

Just installed Rubi rear 44 and need to wire up the pump to my rocker switch. Just don’t know which wires to use from the pump to the switch! I’d also like to wire the indicator sensor to the light on the switch so I know when it’s engaged. Thanks in advance!

Just got a rear Dana 44 but the brackets were all toast so ordered all new Barnes upper, lower, and shock brackets for the axle side only… just wondering if I need to set the shock brackets at a certain angle as Barnes doesn’t have instructions. Thanks in advance!

I actually did get it to work! I didn’t think to take a pic of the final product but it ended up being more simple than I thought. Thanks for your help!

Got it to work! Thanks so much for taking the time to help.

Thank you so much. I will try in the morning!

This pic is what I copied exactly to my harness. Sorry I have a hard time understanding schematics. So maybe the picture is wrong?

Oh sorry I didn’t see your post! I will look back at it. Thank you