Recent content by TrevorT

Wonder what the load rating is on your tires. I have Yokohama Geolander MT 33x12.50r15’s. Max PSI is 35 psi on the sidewall. I run them at 24 psi. I work at a tire shop and we use load calculators to determine proper tire pressure. We take the OE tire’s load and compare it to the new tires load...

Trying to track down a heavy shimmy I’m getting. Recently replaced the tie rod end on the drivers side and noticed that it’s on backwards. The only offroad shop near me is the one that installed the lift for the P.O. After the new tie rod end, it was aligned. About a week ago this shimmy has...

Darryl, Did you ever come across any leads. I too have the same issue, fortunately it’s only one of the latches on the front half of the passenger side. My window slightly opens when driving and I’m wanting to fix this issue. All of my research has led me to to understand that SteelHorse is out...

Update, the part number ES3095R worked. Taking it to a shop on Tuesday and getting an alignment done and seeing if they will check everything else and make sure the PO didn’t have anything else messed up

Thanks. I think they just had it on backwards. Since it’s just a straight bar. I had a part delivered and will update if it works. Just a few more hours of work and I can enjoy the holiday weekend!

It all looks stock to me. I’m starting to think when the PO had work done, they put the tie rod on backwards and I’m trying to feed the left outer into the side the right inner should go in.

Also worth noting the zerk fitting is on the side of the tie rod end, not the bottom, does this mean I have a different steering system?

Front of the jeep is on jackstands for the holiday weekend. Trying to replace the tie rod end on the left outer tie rod. I initially ordered the wrong one from Moog. I ordered the one that connects to the pitman arm. So in a pinch, I grabbed one from AutoZone, it says it’s for the outer left tie...

I just ran into a similar situation. I put in a stant 195 back in July when I got my jeep. Replaced the water pump, thermostat, and flushed the heater core. Purged all the air from the system and all seemed fine. Heat was never really amazing but I figured it is 27 years old, just be glad it...

Allegedly they don’t make a Speedo gear for my situation. I still have stock 3.07 gears and I have 33s. I’ve kinda gotten used to it at this point but my Speedometer is off by almost 10 at highway speeds. I’d consider an electric solution. Looking at it, I really need to regear my jeep but then...

I I believe I ended up going with the EP26 for my 1997. Sure was a pain to get to since my tilt steering doesn’t tilt

I changed my relay when I went all LED, little did I know there were different styles of relays and mine had an extra prong so I had to order another one. I hated the hyper flash. Only issue I need to resolve is when I hit the brakes, my left turn signal will go solid unless I bump the turn...

Yeah had to put that DJI to work. It turned out pretty good 🤣

Peeled the old wrap off this hood and installed a black wrap to match the rest of the paint. Turned out quite well. If only there wasn’t so much pollen and wind today, might have been done 2 hours earlier.