Recent content by Steveorino

And now I have done the front seat bushings too. I don't normally have too many passengers so I imagine that these should last a little while for me. If not then I'll print some replacements. There are only using about 4g of filament. https://makerworld.com/en/models/86225#profileId-92114

I've modelled and printed a replacement bushing for the rear seat of a 1997 Jeep Wrangler TJ. I had the plastic bushing on one side of the tub but not the other. The genuine Mopar part is 5103469AA Bushing-Pivot but this could be used as a temporary fix...