Recent content by sasnak

  1. sasnak

    Long crank on cold start

    That turned out to be the problem. Weak spark. New Coil and starts like new. Thank you all for your help.
  2. sasnak

    Long crank on cold start

    i gleaned that i am not up the the task of what that guy was doing to test the CPS.
  3. sasnak

    Long crank on cold start

    well back to the drawing board. Back from trip and took 4 tries to start. Only thing i have not changed is the IAC? Have cleaned it. I am guessing is not getting enough gas to start. what controls the choke function when starting?
  4. sasnak

    Long crank on cold start

  5. sasnak

    Long crank on cold start

    Well I took ground wire off for a couple hours then reconnected and stTed right up. Need to reset map i guess. I think all good. Will be in Colorado for a week. Will see when I get back
  6. sasnak

    Long crank on cold start

    well i spoke to soon. Started right up yesterday. this morning took 3 tries like usual. Not idling smoothly like it was. Just unbelievable. I did not disconnect the battery, will try that to see if the map needs to be updated.
  7. sasnak

    Long crank on cold start

    Well after $300 of swapping parts i finally found the right one. Mass Air flow Sensor. Starts right up. Thanks for all the help on the forum. Wanted to change the injectors anyway, so i am happy. Runs like new now. Mark
  8. sasnak

    Long crank on cold start

    i have a 1999, and does not have OPDA. I have a distributor. the cam position sensor is a round disc that sits inside the distributor and locked down with the dist cap.
  9. sasnak

    Long crank on cold start

    I am just following what people have been suggesting to do based on what is happening. Just removed the dist cap and rotor and all look as new. the cam position sensor has been replaced right after i purchased along with the dist cap, plugs, and wires
  10. sasnak

    Long crank on cold start

    tried that, made no difference. however it did backfire the next time i tried to start. That is a first. going to look at dist cap and timing next.
  11. sasnak

    Long crank on cold start

    I agree never thought that would work, but trying anything at this point. I am probably going to take to local garage guy I know and have him hook up his scanner and see if he gets any codes.
  12. sasnak

    Long crank on cold start

    I do have AC however i have not had the AC on yet this year. So no drag.
  13. sasnak

    Long crank on cold start

    OK - here you go
  14. sasnak

    Long crank on cold start

    I did have fuel pressure gauge on after i replaced fuel pump, was 50 as soon as i turn on the key. dont have a way to log the ODB data. Added video yesterday
  15. sasnak

    Long crank on cold start

    https://youtu.be/kfBDmfaC9kc Video for Hard start.
See more
Top Bottom