Recent content by richard-jefferson

Good. Thanks for your input. Ill update in a couple of weeks.

Hi Sab. No codes being thrown. I rechecked the with set sync function and its within range.. its running between -1 and 1 with a target of 0. I did find an aftermarket mopar sensor at partsbreakers.com which they sold together with the oil pump drive. Im waiting to see if it straightens...

I originally sought recommendations from an "expert" on Just Answer back in September. They recommended NTK, BOSCH or DELPHI. I ordered a Delphi and can tell you that made things worse. I took it out in less than 5 miles. I can also tell you that I did not do the Set Sync procedure on it...

Thanks for the link. is it the height that is the issue with the current body lift or the quality of the material used in the pucks?

Ive had this jeep for about 10 years and drive it a lot. When I bought it, I think the guy had 33's or 35's on it. i dont remember. they were stolen from my garage. So what is the down side of these body lifts and what would you replace them with?

Hi. I'm assuming this is a Body Lift. Can anyone tell me what measurement to take that will tell me how much lift? I want to replace the shocks. Does the body lift impact what shocks I need? Thank you.

I wanted to provide an update and solution this problem. Its been a couple thousand miles. The bottom line is that after replacing the camshaft position sensor it had to be resynced with a "SET SYNC" function on a scan tool. I thought that I was in the clear but it started getting progressively...

Hi, I just wanted to give you an update. I could not find any of my friends or small shops that had a dbrIII. I read in the discussion that the Autel might work. I got the Autel MK 808S and it had the set sync function. Problem solved. i was out of range by about 13 degrees. running great...

I wanted to provide an update and a thank you to everyone. I ended up replacing the sensor with a NAPA Echlin brand. Ive driven it over 400 miles and so far so good. I did not do a set sync on it yet (still trying to find someone who has a tool that will do it). I also have not replaced...

Thank you sab. If the site the boogieman gave me has the sensor, Ill get that one. if not, ill try NAPA Echlin brand. If I get the one from NAPA and have to do a SET SYNC function, Ill have to track down a shop that has a sorry, still figuring out how to post and reply here. Ill have...

Thank you. I have sent that seller a message to see if the CPS is still available.

2003 Rubicon. Throwing codes P0340, P1391 and P0300. Running rough when calling for power (acceleration and upshifting) some backfiring. Cannot find a Mopar anywhere. Replaced CPS with a Delphi from rock auto. This made it much worse. I switched back to the old one after 10 miles. Does anyone...