Recent content by Obi-Wan

  1. Obi-Wan

    Power hungry 4.0: how to give it what it wants?

    I too am a purist. The 4.0 is a great engine and pairs with the TJ incredibly well. With that being said, I wish I had put the 5.3 LS I have in now 10 years ago. The difference is above and beyond what the 4.0 could give me.
  2. Obi-Wan

    New member with a new to me Jeep seeking advice

    Patriot Blue looks so friggin good on these.
  3. Obi-Wan

    Engine Oil Recommendation

    I believe it was Tom and Ray who suggested the virtues of using Filippo Berio Extra Virgin olive oil on several occasions.
  4. Obi-Wan

    Offset balljoints: good, bad, and ugly?

    When I bought my 04 back in 08, I found that my front passenger tire developed abnormally high wear on the inner edge compared to the rest. Took it to have it aligned and found that the camber for that wheel was off by almost 1°. Installed a set of offsets and have had no issues since. At the...
  5. Obi-Wan

    Spicer made in China? Say it ain’t so!

    * For use in PTO applications only. See www.SVLparts.com for more information. It was bothering me not knowing what the asterisk was for.
  6. Obi-Wan

    What did you do to your TJ today?

    Is this a metaphor?
  7. Obi-Wan

    Long Ranger auxiliary fuel tank

    ONLY FIVE "O's" ????!!!! THIS IS NOT @Zorba APPROVED!!!!! The wet noodle awaits you sir.
  8. Obi-Wan

    42RLE automatic transmission shifting issue

    I know you posted as a 2008, but your profile says 2005. Can you be specific in how you changed the fluid? Did you check the level per the owners manual instructions for your automatic? It sounds like it's low on fluid.
  9. Obi-Wan

    What have you 3D printed for your TJ?

    Yep. You want to glove and mask up when you're handling that shit.
  10. Obi-Wan

    What have you 3D printed for your TJ?

    I ran several Ender 3 V2 rigs for years. I used them to teach myself the ins and outs of printing, then upgraded to a X1C and holy hell was it nice to send it a print and know it was just going to work. And with the price of an A1 at $299, it's a no brainer to start there. @John Cooper, If you...
  11. Obi-Wan

    What have you 3D printed for your TJ?

    I count six O's. That's @Zorba approved.
  12. Obi-Wan

    Replaced Starter, now it won't even click!

    98.65874% of issues like this are caused by poor grounds.