Recent content by Jeep345

Hi all, I’ve been having this misfiring engine for a while now. It sometimes doesn’t trigger a CEL and sometimes does. Seem to happen on start up or when turning and hitting gas. Also noticed it more, when running low on gas. It goes away when I pull over and restart the engine, sometimes...

Hi all - installed pcm yesterday. Just took it for a drive. No hard shift and seems to be able to get up to speed quicker. On that front I think I’m sorted. However still having issues with misfiring and still throwing the p2302 code. Will update over the following days, but guessing the...

Hi all, Today I installed new antenna and speakers. The day went as follows: - new antenna installed no problem - check to see if working and radio volume won’t go up from 0. (Noticed same issue last week when just fiddling around with radio in traffic) - disconnect and reconnected battery. -...

Just placed my order with wranglerfix. Will update everyone once installed.

Hi - just want to update so the thread doesn’t die unanswered. My conclusion: 1. The fuel pump issue - dropped the tan pump looked fine. Tried to check as much of cable as possible, no chaffing found…. I decide to just run a new cable from relay all way to the pump. I used bullet connections...

Hi mark - it’s an auto and not sure on battery age, bought the car 3 months ago so I’d probably say between 1 and 2 years old.

I checked all the continuity and ohm didn’t seem to find any issues.. I only changed the wire as I’d rather change the wire than the fuel pump and still have an issue. Will update over next few days as to if the fuse blows again. Yes original PCM. I did have an issue where the car would hard...

My 06 jeep wrangler straight 6 has the following issues: has been running rough and throwing up the engine code p2302 (ignition coil circuit 1). Replaced the ignition coil and ran ok then started misfiring again and throwing up same code. any advice? 2). The fuel pump fuse randomly blows. I...