Recent content by JC-8

got the ken worth ploy and rubber, but before I destroy those.... where do they explain this from your post: "you will adjust caster and bushing preload later". caster is easy.... preload apparently for me is not. lol maybe it isn't discussed later in the installation instructions?

Thanks Daryl! I got the replacement bushings from ALL J which are both polyurethane ( hard and very hard I'd say) I found that you can get some Kenworth bushings poly and rubber so going to try that. Your advice on the rubber bushing is where I'll try. I think I over tightened the 2 poly ones...

hello all, Does anyone have the approximate torque for the FUCA bushings? I just installed a set of poly-urethane ones and they split and were useless on an offroad trip. ( ended up welding a piece of angle that eliminated the cushioning effect of the bushings. I tightened to the point of a...

Willywill989 or anyone else with the LJ kit can you measure your rear arms? Just to confirm length. Much appreciate!

I didn't mention that I will be swapping axles as a phase 2 ( winery 25-26). Phase 1 winter 24-25 is TJ6 I figured it would be easier and more cost effective to keep what I have and then consider a 4 link rear ( double triangulated, no panhard)

Thanks. That's the plan, can use LJ hard top or soft top.

hello, I'm thinking about doing the TJ-6 mod and wondering if someone could tell be how much longer the "stretch" was on the LJ kit......simple enough on the lower arms ( I'll assume 10"). Was the stinger 10" longer as well? I have the long arm 6" lift on my '03 TJ Thanks for your help! J