Recent content by Intimnasc

I ran CRC Fule Treatment through my Jeep right after I bought it and cant say yeah or nea but I ran it through the GF's Dodge pickup that would not start and it is running like a top. Ran it in the gas tank and sprayed Berrymans in the intake to get it started. She only drives it like 10 miles a...

When I weld my Johnny Joint bracket on my front axle I think I am going to get a set of these as well (looks like low hanging fruit). Is it a good idea to put them on the rears as well or am I being an idiot? Again I am mostly new to off roading so there will always be an occasional dumb question.

Thanks a lot mrblaine I think I just spit coffee on my keyboard while catching up on the forums.

So after 6 weeks my control arms are here, skid plates are here and at powder coat (should have them next week), track bars are here, and front upper axle housing Johnny Joints are here. I cant start this weekend as there is some weather incoming and I have to support the factory but next...

So next phase was to install and wire the new light switches to the new relays. Wow behind these dash boards it is crowded. Picked up an ignition hot to feed the switches and wired them to the relays. Next phase is wire in all the new lights. I will have at this point one NO relay and 2 dual...

Oh hell grow a pair and smack him down he puts his pants on one leg at a time LOL

My thoughts exactly just didn't know if there may be some known flaw. Thanks man

So my control arms are finally here (6 weeks) from Savvy and my skid plates from Undercover arrived. After lifting the skid plate I've decided to put the new clutch on when I do the skid plate was really heavy for a guy my age). Before I do all this is there any reason I should buy a new...

Was a great day pulling a Rivian out of shit lol.

I was in the process of adding up fitter switches to my dash and this connector was plugged into an empty slot next to the Rubicon locker switch. Anyone know what it is and if one of those is an ignition hot? I know I can plug a meter into it and turn the key on but I still wanna know what it is...

LOL almost sounds like a trick question. So many people follow so many different thoughts and opinions but I personally run Amsoil in everything I own.

That is basically what the guy from Tom Woods told me on the phone. As long as you don't get vibration you are probably ok. I was concerned about doing without the jeep while I waited on the new shaft and he said as long as I call him on Monday morning it will almost always be delivered by...

So when I added the 1" MML it made a huge difference. I was able to totally remove the T-case drop and no problems as yet. I'm on a 4 inch lift, 1" MML, and 1.25" body lift with T-case back in stock position. I call Tom Woods and spoke to their main guy about when my control arms get here and I...

So it was time to do a wir kit and add relays and fuses for accessories. 1/0 to the first fuse block and 1/0 to the alternator. 1/0 to the engine block for the ground as well. Winch is now on a 400 amp fuse and I added a plug at the front for jumper cables. I'll add switches in the dash for the...

Please tell me which iglooed up eskimo is you? hahahahha