Recent content by hamhawk

Its just a standard fan. I seem to remember reading the pulsing of the output was for "soft start" on the fan, i want to say it was a grand cherokee feature but cant remember. Set up the way it is works for me, so i havent dug any deeper into it.

Its a tj pcm with a xj tune file. Its a simple on/off. I played with all the settings for a hi/low setup, but it didnt seem like anything but the on/off worked. I havent played with any pwm stuff, not sure if the jtec pcm supports it.

What info you looking for? Ive been running the ecm controlled fan on mine since feb 2024 with no issues.

Snatched the axle out of the big jeep for some maintenance. Axle shaft seals and an unknown leak on the arb. Turns out its the bonded seal inside the locker. Luckliy its under warranty. My dealer buddy is going to order the seal monday.

I dont know, man. I'm gonna keep this one around. Its hard to find one like this. 🤣

Got the park brake cables for the disc brake 44 swap installed. Had to enlist the assistance of my wife.

Finally got around to installing the 4.88s in the hp30 and (used) currectlync steering on the little tj. Had some assistance from my buddies since im laid up with a bad arm.

I was going to have him machine the plug, but i have another set of superduty axles to gear and the shoulder would have been too small to catch the carrier. Worked out better this way for me.

Yeah 😂. My buddy bought it to regear his jkur, and we ended up just stacking sockets in the tube. He gave it to me after we finished regearing his. Its been sitting on the shelf in the garage since november, and i dropped it off with my machinist buddy monday. Has about .010 clearance on...

Yeah 😂. My buddy bought it to regear his jkur, and we ended up just stacking sockets in the tube. He gave it to me after we finished regearing his. Its been sitting on the shelf in the garage since november, and i dropped it off with my machinist buddy monday.

Machined wrong like the plug piece wont fit in the tube? Thats how mine was, and i just picked it up from my machist buddy earlier today after he machined the inside diameter of the tube. Putting 4.88 revolution gears in mine now.

Every rig ive seen run that lifts the driver front. Its just a weird spot.

Its damn sure not a dana 60 on 43s, but itll work

Threw some axle shaft seals in this hp30 to swap into the daily driver on 35s

Whats a good time of the year to wheel up there? Ive seen some videos posted around september, and it looked pretty good.