gasiorv

Birthday: Mar 30, 1973 (Age: 52)

Location: Memphis, TN

Gender: Male

What year is your Wrangler?: 2004

What model is your Wrangler?: Rubicon

What engine is in your Wrangler?: 4.0

What kind of transmission is in your Wrangler?: 5-sp

What mods do you have?: 4" currie springs
1.25" BL (only front has aluminum pucks, all remaining side and aft body mount locations have been raised 1.25")
1" MML
UCF ultra clearance tranfer skid
UCF motor/tran skid
38x14.5x17 GY MT/R on 17x9.5" Raceline Monster beadlocks (4" backspace) with 1.25" wheel spacers.

Front Axle: Currie HP44 Front Axle 5.13:1, RCV axle shafts with Grizzly locker.
American Iron Ball Joint Eliminators, stock knuckles and stock unit bearings.
TNT lower control arm brackets and 3” stretch coil spring pads with stock track bar mount location.
TMR Simple Dana 44 front truss (½” thick) with TMR 2-⅝ mounting bracket for upper control arm mount.
Front axle is pushed fwd approx 3”, Steering Box is rotated and flat pitman arm is installed.
Currie TrackBar with the frame side Johnny Joint rotated 90 deg and custom frame side mount located approx 3-3.5” forward of factory location.
Currie currectlynk steering w/ BMB tie rod
PSC 1.5x6.0 hydro assist ram with PSC Big Bore XD steering box
PSC PS pump with smaller pulley and remote reservoir
BMB PS cooler
Front Suspension: Custom 3 link “mid arm” length, AL WOD links and johnny joints, approx 29” link length. Currie 4” coil springs, Bilstein 5100 shocks.
Antirock front

Rear Axle: Currie RJ60 Rear with Detroit, 5.13:1
Rear Axle is pushed back 7.5" by cutting the frame and pushing the hoop back 7.5".
Rear is custom triangulated "mid-arm" using GR brackets, AL WOD links, and Johnny Joints
Currie 4" springs
Bilstein 5100 shocks (rear shocks are outboarded)
Antirock rear

Tom Woods Rear Drive Shaft (Double Cardan) 24.5" long due to 7.5" stretch. Rubicon flange, 1310 doubler cardan and 1330 big cap on yoke side.
Tom Woods front drive shaft, 44 1/2 “ long due to HP44 and front stretch. 1330 big cap on yoke side.
Custom roll cage
GR23 Crawler Fuel Tank (installed in the bed)

PRP Daily Driver seats (driver and passenger)
Crawltek Inferno Highline fenders, cut hood with Daystar hoodpins.