macleanflood

Supporting Member Ride of the Month Winner

I break sh!t From Fall Creek, OR

Joined: Jul 24, 2021

Last seen: Today at 9:25 PM Viewing forum TJ General Discussion

Latest activity Postings Attachments Images About

- macleanflood reacted to CES22's post in the thread Need help finding heater hose inlet connector for 2005 TJ SE 2.4 with Like.
  
  @macleanflood ordered and hoping for the best. Thanks for the input
  
  Today at 9:13 PM
- macleanflood reacted to OldBuzzard's post in the thread Bad gas mileage with Like.
  
  Yes.
  
  Today at 8:38 PM
- macleanflood reacted to All 4 Wheelin''s post in the thread What did you do to your TJ today? with Like.
  
  That is alot of tape and mud. Been there, done that. Don't want to do it anymore.
  
  Today at 8:36 PM
- macleanflood replied to the thread What did you do to your TJ today?.
  
  Especially once I get the HVAC going...been sheetrocking my ass off...48 x 48 ceiling and two walls fully taped by hand...1250 feet...
  
  Today at 6:27 PM
- macleanflood reacted to hear's post in the thread What did you do to your TJ today? with Like.
  
  we could build a lot of transmissions in that shop.
  
  Today at 6:23 PM
- macleanflood replied to the thread What did you do to your TJ today?.
  
  Come to Oregon. Gene Stringfield. Built my whole shop with their wood. Straight boards, tight rings, great prices. -Mac
  
  Today at 5:09 PM
- macleanflood reacted to Daryl's post in the thread Dana 35 pinion offset with Like.
  
  Or a speedi-sleeve.
  
  Today at 4:42 PM
- macleanflood reacted to GregBelleville's post in the thread Motor mounts with Like.
  
  Would you say you have a plethora of socket extensions?
  
  Today at 3:21 PM
- macleanflood reacted to Rancho LJ's post in the thread Luke warm Air with Like.
  
  Assuming the 03 is similar to the 05, you can access the actuator from the passenger side footwell. Let the engine heat up so you have...
  
  Today at 3:18 PM
- macleanflood reacted to hear's post in the thread 2004 4.0 LJ Auto - Fuel Rail Pressure questions. with Like.
  
  Very likely I'm going to do the same. I'm sure Glowshift is no Autometer, but for my purposes it's perfectly fine and in some ways...
  
  Today at 3:17 PM
- macleanflood replied to the thread Dana 35 pinion offset.
  
  Those grooves are deep enough you probably could fix it with an o-ring. =) -Mac
  
  Today at 3:16 PM
- macleanflood reacted to hosejockey61's post in the thread Dana 35 pinion offset with Like.
  
  If it's just a normal nut, then yes. If it's a flange nut, then no.
  
  Today at 3:16 PM
- macleanflood replied to the thread Car changes gears but won’t move.
  
  And your original problem was probably the PCM. I'd fill up and reinstall the original torque converter and consider replacing the pump...
  
  Today at 8:02 AM
- macleanflood reacted to NashvilleTJ's post in the thread Car changes gears but won’t move with Like.
  
  You need to fill the converter when you install it. That could be the problem. Although it will fill eventually, dry starting can...
  
  Today at 8:01 AM
- macleanflood reacted to Rancho LJ's post in the thread Remove RTV from oil pan gasket with Like.
  
  Following this thread worked for me. Dry since April. I used a Mopar RMS and followed tips on cleaning the groove...
  
  Today at 4:57 AM
Show older items
Loading…
Loading…
Loading…
Loading…

Top Bottom

Search

Search

macleanflood

Find content

Latest activity Postings Attachments Images About